Point Light Attenuation

From Bakery GPU Lightmapper: Wiki
Revision as of 22:59, 29 May 2019 by Mr F (talk | contribs)
Jump to navigation Jump to search

Explanation

Comparison of different falloff curves

In real world, lighting attenuation is governed by the inverse-square law: Falloff ph.png

However, in computer graphics things are a little trickier. Inverse-square law works for real lights because they have area, hence the projection of this area on receiver geometry gets exponentially smaller with distance. Point lights are an approximation and using the law on them produces one obvious problem: as distance approaches zero, lighting intensity approaches infinity.

There are multiple ways to solve it.

Standard Unity rendering pipeline uses a completely fake falloff curve that looks similar to this: Falloff unity.png

r = Light Range

This is an arbitrary hand-tweaked function. It has a nice property of being exactly 1 in the center, but its falloff is basically always locked and distance-independent. It simply scales the same gradient based on Range parameter. That allowed Unity to even store it inside a texture. A 8-bit texture unfortunately, that also lacks precision and produces visible banding when rendering with gamma correction.

Bakery's "physical falloff" defaulted to a different formula: Falloff bakery legacy.png

This function tries to combine best of both worlds, by having 1 at center and falling off exponentially. A similar function is also used in UE4 (you need access to UE4 github repository to open that link).

However, the "1" constant in this case is arbitrary and will look different depending on scene size/units.

Frostbite and HDRP use almost unfiltered inverse-square falloff, but clamp it to prevent dividing by zero: Falloff hdrp.png

s = Light Size

Frostbite paper

In both of these renderers, light size is hardcoded to be 0.01 (1cm), which means brightest value of the untinted light is 10000.

Bakery has an option called Falloff min size. This is exactly the Light Size used in HDRP/Frostbite formula. With this parameter, new Bakery falloff looks like that: Falloff bakery.png

With Light Size being 0.01, it looks similar to HDRP formula. With a value of 1 it works like the original Bakery falloff.

What value should I use?

When matching Bakery light to a HDRP light, Faloff min size will be automatically set to 0.01 to look identical. This value makes sense if your point light does indeed represent a 1cm emissive surface. However, there are cases when you'd better set it to a higher value:

  • When literally using point lights for larger surfaces (e.g. lamp of a traffic light).
  • When building for mobile platforms where lightmap compression is limited and cannot represent extremely bright values well; or tonemapping not possible.